Dicor COOLCOAT Insulating Rubber Roof Coating

CoolCoat™ is the industry’s first EPDM insulating roof coating, lab proven to reduce heat flux transfer from the roof of your RV to the interior of your RV by 29%

CoolCoat™ starts with 100% elastomeric premium resins, titanium dioxide and zinc oxide to create a brilliant white base pigment. Titanium dioxide and zinc oxide both block the sun’s Ultraviolet and infrared radiation to reflect heat off your roof and back into the air.

CoolCoat™ contains MicroCells™, nano-sized ceramic spheres that are vacuum formed eliminating all gas inside the microsphere. Vacuum technology, used for years in Thermos® containers to keep liquides hot or cold for hours, substantially reduces heat flux transfer from the hot side of your RV roof to the cool side of your RV ceiling. Lab results confirmed that with CoolCoat™, the interior ceiling remained at 76° F when the RV roof was a scorching 107°.

CoolCoat™ means less heat transfer to your interior and that means less demand on your air conditioning, less wear on your compressor and less noise for you and your neighbors.

Application: WHITE ACRYLIC COATING must be preceded with DICOR CLEANER/ACTIVATOR to ensure proper adhesion. All cleaner/activator must be completely removed from roof prior to applying acrylic coating. All surfaces must be clean and free of residue or loose particles, degraded substrate, grease, oil, dirt, or other contaminates. Surfaces shall be completely dry and frostfree before coating. Deteriorated or damaged substrates shall be repaired or replaced.

Apply after using the cleaner/activator with a medium nap roller or brush. One gallon covers up to 125 sq. ft. Actual gallons required will depend onthe type of surface and texture, method of application and weather conditions at the time of application. Surfaces must be uniformly coated and free from voids, pinholes and blisters. CoolCoat shall be applied in a minimum of 2 coats at a rate of 1 gallon per 125 sq. ft. (i.e., 8′ X 30′ roof takes 4 gallons).

NOTE: Entire 2 part project must be completed in one day; including cleaner/activator application, rinsing and 2 coats of CoolCoat™ each dry to the touch.

Preparation: Thoroughly mix the contents for a minimum of 15 minutes prior to application. DICOR ACRYLIC COATING may be applied by medium nap roller or brush. Clean equipment with water and a universal cleaner.

CAUTION: CAN CAUSE IRRITATION OF NOSE, THROAT AND LUNGS; CAN CAUSE NAUSEA AND HEADACHE. Prolonged or repeated breathing of vapor or spray mist may be harmful. Use a respirator for protection from vapor or spray mist. Avoid eye and skin contact. Do not take internally. Wash thoroughly after handling and before eating or smoking. Keep container closed when not in use.

Contains: Aqueous Acrylic Emulsions, Calcium Carbonate (471-34-1), Aluminum Trihydroxide (1645-51-2), Titanium Dioxide (13463-67-7)

KEEP FROM FREEZING • USE ONLY IN A WELL VENTILATED AREA
CAUTION: KEEP OUT OF REACH OF CHILDREN